Figure 40: Ethernet Cable Connector - Juniper EX3300 Complete Hardware Manual

Complete Hardware Guide for EX3300 Ethernet Switches
112
to the management console or to a console server. The console port accepts a cable
with an RJ-45 connector.
Ensure that you have an Ethernet cable with an RJ-45 connector available. An RJ-45
cable and an RJ-45 to DB-9 serial port adapter are supplied with the device.
Figure 40 on page 112 shows the RJ-45 connector of the Ethernet cable supplied with the
device.

Figure 40: Ethernet Cable Connector

NOTE: If your laptop or PC does not have a DB-9 male connector pin and you
want to connect your laptop or PC directly to the device, use a combination
of the RJ-45 to DB-9 female adapter supplied with the device and a USB to
DB-9 male adapter. You must provide the USB to DB-9 male adapter.
To connect the device to a management console (see
Figure 42 on page 113):
Connect one end of the Ethernet cable into the console port (labeled
1.
or ) on the device.
CON1
For the location of the CON/CONSOLE
See EX2200 Switches Hardware Overview.
See Rear Panel of an EX3200 Switch.
See "Rear Panel of an EX3300 Switch" on page
See Rear Panel of an EX4200 Switch.
See EX4300 Switches Hardware Overview
See Front Panel of an EX4500 Switch.
See EX4550 Switches Hardware Overview
See Switch Fabric and Routing Engine (SRE) Module in an EX6200 Switch.
See Switch Fabric and Routing Engine (SRE) Module in an EX8208 Switch.
See Routing Engine (RE) Module in an EX8216 Switch.
See Front Panel of an XRE200 External Routing Engine.
See Management Panel of an EX4600 Switch
OCX1100 Switches Hardware Overview
Connect the other end of the Ethernet cable into the console server (see
2.
Figure 41 on page 113) or management console (see
Figure 41 on page 113
port on different devices:
7.
Figure 42 on page
Copyright © 2015, Juniper Networks, Inc.
and
, ,
CON CONSOLE
113).