Mounting An Ex3300 Switch On Four Posts In A Rack Or Cabinet - Juniper EX3300 Complete Hardware Manual

Related
Documentation

Mounting an EX3300 Switch on Four Posts in a Rack or Cabinet

Copyright © 2015, Juniper Networks, Inc.
Connecting Earth Ground to an EX Series Switch on page 99
Connecting AC Power to an EX3300 Switch on page 105
Connecting DC Power to an EX3300 Switch on page 107
Connecting and Configuring an EX Series Switch (CLI Procedure) on page 119
Mounting an EX3300 Switch in a Recessed Position in a Rack or Cabinet on page 90
Rack-Mounting and Cabinet-Mounting Warnings on page 164
You can mount an EX3300 switch on four posts of a 19-in. rack or cabinet by using the
separately orderable four-post rack-mount kit. (The remainder of this topic uses "rack"
to mean "rack or cabinet.")
You can mount the switch on two posts in either a two-post rack or a four-post rack by
using the mounting brackets provided with the switch. See
on Two Posts in a Rack or Cabinet" on page
NOTE: If you need to mount the switch in a recessed position on either a
two-post rack or a four-post rack, you can use the 2-in.-recess front-mounting
brackets provided in the separately orderable four-post rack-mount kit.
Before mounting the switch on four posts in a rack:
Verify that the site meets the requirements described in
for EX3300 Switches" on page
Place the rack in its permanent location, allowing adequate clearance for airflow and
maintenance, and secure it to the building structure.
Read "General Safety Guidelines and Warnings" on page
to "Chassis Lifting Guidelines for EX3300 Switches" on page
Ensure that you have the following parts and tools available:
Phillips (+) screwdriver, number 2
6 flat-head 4-40 mounting screws (provided with the four-post rack-mount kit)
8 flat-head 4x6-mm Phillips mounting screws (provided with the four-post rack-mount
kit)
One pair each of flush or 2-in.-recess front-mounting brackets
One pair of side mounting-rails
One pair of rear mounting-blades
Screws to secure the chassis and the rear mounting-blades to the rack (not provided)
"Mounting an EX3300 Switch
84.
"Site Preparation Checklist
55.
149, with particular attention
Chapter 9: Installing the Switch
163.
87