Table 9: Status Led On The Network Ports In Ex3300 Switches - Juniper EX3300 Complete Hardware Manual

Table 9: Status LED on the Network Ports in EX3300 Switches

LED
Status
Copyright © 2015, Juniper Networks, Inc.
LCD Indicator
LED: SPD
LED: ADM
LED: DPX
LED: POE
Chapter 2: Component Descriptions
State and Description
Indicates the speed.
The status indicators are:
Unlit—10 Mbps
Blinking—100 Mbps
On steadily—1000 Mbps
Indicates the administrative status. The status indicators are:
On steadily—Port is administratively enabled.
Off—Port is administratively disabled.
Indicates the duplex mode.
The status indicators are:
Green—Port is set to full-duplex mode.
Unlit—Port is set to half-duplex mode.
Indicates the PoE status.
The status indicators are:
On steadily—PoE is available on the port.
Blinking—PoE is available on the port, but no power is drawn
from the port because of one of the following:
No device that draws power from the port is connected
to the port.
A device that draws power from the port is connected to
the port, but the device is not drawing any power from
the port.
Unlit—PoE is not enabled on the port.
19