Juniper EX3300 Complete Hardware Manual page 136

Complete Hardware Guide for EX3300 Ethernet Switches
120
NOTE: EX2200-24T-4G-DC switches do not support switch connection and
configuration through the J-Web interface.
This topic describes the CLI procedure.
NOTE: To run the
configuration as the active configuration. If you have configured anything on
the switch and want to run
See Reverting to the Default Factory Configuration for the EX Series Switch.
Using the CLI, set the following parameter values in the console server or PC:
Baud rate—9600
Flow control—None
Data—8
Parity—None
Stop bits—1
DCD state—Disregard
script, the switch must have the factory default
ezsetup
, revert to the factory default configuration.
ezsetup
Copyright © 2015, Juniper Networks, Inc.