Mounting An Ex3300 Switch On A Desk Or Other Level Surface - Juniper EX3300 Complete Hardware Manual

Related
Documentation

Mounting an EX3300 Switch on a Desk or Other Level Surface

Copyright © 2015, Juniper Networks, Inc.
To mount the switch in a recessed position on four posts, follow the instructions in
"Mounting an EX3300 Switch on Four Posts in a Rack or Cabinet" on page
the switch in a recessed position on two posts, follow the instructions in
EX3300 Switch on Two Posts in a Rack or Cabinet" on page
Connecting Earth Ground to an EX Series Switch on page 99
Rack-Mounting and Cabinet-Mounting Warnings on page 164
You can mount an EX3300 switch on a desk or other level surface by using the four rubber
feet that are shipped with the switch. The rubber feet stabilize the chassis.
Before mounting the switch on a desk or other level surface:
Verify that the site meets the requirements described in
for EX3300 Switches" on page
Place the desk in its permanent location, allowing adequate clearance for airflow and
maintenance, and secure it to the building structure.
Read "General Safety Guidelines and Warnings" on page
to "Chassis Lifting Guidelines for EX3300 Switches" on page
Ensure that you have the following parts and tools available:
4 rubber feet to stabilize the chassis on the a desk or other level surface (provided in
the accessory box in the switch carton)
To mount a switch on a desk or other level surface:
Remove the switch from the shipping carton (see
1.
page 82).
Turn the chassis upside down on the desk or the level surface where you intend to
2.
mount the switch.
Attach the rubber feet to the bottom of the chassis, as shown in
3.
Turn the chassis right side up on the desk or the level surface.
4.
"Site Preparation Checklist
55.
149, with particular attention
"Unpacking an EX3300 Switch" on
Chapter 9: Installing the Switch
87. To mount
"Mounting an
84.
163.
Figure 28 on page 92.
91