Management Port Connector Pinout Information For An Ex3300 Switch; Table 18: Management Port Connector Pinout Information For Ex3300 - Juniper EX3300 Complete Hardware Manual

Related
Documentation

Management Port Connector Pinout Information for an EX3300 Switch

Table 18: Management Port Connector Pinout Information for EX3300 Switches
Pin
1
2
3
4
5
6
Copyright © 2015, Juniper Networks, Inc.
Table 17: RJ-45 to DB-9 Serial Port Adapter Pinout Information (continued)
RJ-45 Pin Signal
7 DSR
8 CTS
Connecting a Switch to a Management Console on page 111
Connecting and Configuring an EX Series Switch (CLI Procedure) on page 119
Connecting an EX9200 Switch to a Management Console or an Auxiliary Device
Connecting and Configuring an EX9200 Switch (CLI Procedure)
Connecting and Configuring an OCX1100 Switch (CLI Procedure)
The management port on an EX3300 switch uses an RJ-45 connector to connect to a
management device for out-of-band management.
The port uses an autosensing RJ-45 connector to support a 10/100BASE-T connection.
Two LEDs on the port indicate link/activity on the port and the administrative status of
the port. See "Management Port LEDs in EX3300 Switches" on page
Table 18 on page 29 provides the pinout information for the RJ-45 connector for the
management port. An Ethernet cable, with an RJ-45 connector attached, is supplied with
the switch.
Signal
TRP1+
TRP1-
TRP2+
TRP3+
This pin is used only when the port is
operating at 1000 Mbps.
TRP3-
This pin is used only when the port is
operating at 1000 Mbps.
TRP2-
Chapter 3: Component Specifications
DB-9 Pin Signal
4 DTR
7 RTS
20.
Description
Transmit/receive data pair 1
Transmit/receive data pair 1
Transmit/receive data pair 2
Transmit/receive data pair 3
Transmit/receive data pair 3
Transmit/receive data pair 2
29