Chassis Lifting Guidelines For Ex3300 Switches - Juniper EX3300 Complete Hardware Manual

Chassis Lifting Guidelines for EX3300 Switches

Related
Documentation
Copyright © 2015, Juniper Networks, Inc.
Connecting DC Power to an EX9204 Switch
Connecting DC Power to an EX9208 Switch
Connecting DC Power to an EX9214 Switch
Connecting AC Power to an XRE200 External Routing Engine
Connecting DC Power to an XRE200 External Routing Engine
Connecting AC Power to an OCX1100 Switch
Connecting DC Power to an OCX1100 Switch
Connecting AC Power to a QFX3100 Director Device
Connecting AC Power to a QFX3008-I Interconnect Device with Single-Phase Wiring
Trays
Connecting AC Power to a QFX3008-I Interconnect Device with Three-Phase Delta Wiring
Trays
Connecting AC Power to a QFX3008-I Interconnect Device with Three-Phase Wye Wiring
Trays
Connecting AC Power to a QFX3500, QFX3600, or QFX3600-I Device
Connecting DC Power to a QFX3500, QFX3600, or QFX3600-I Device
Connecting AC Power to a QFX5100 Device
Connecting DC Power to a QFX5100 Device
The weight of a fully loaded EX3300 switch chassis is approximately 10 lb (4.5 kg).
Observe the following guidelines for lifting and moving an EX3300 switch:
Before installing the switch, read the guidelines in
EX3300 Switches" on page 55
power, environmental, and clearance requirements.
Before lifting or moving the switch, disconnect all external cables.
As when lifting any heavy object, lift most of the weight with your legs rather than your
back. Keep your knees bent and your back relatively straight and avoid twisting your
body as you lift. Balance the load evenly and be sure that your footing is solid.
General Safety Guidelines and Warnings on page 149
Installation Instructions Warning on page 161
Mounting an EX3300 Switch on page 84
Chapter 18: Installation and Maintenance Safety Information
"Site Preparation Checklist for
to verify that the intended site meets the specified
163