Misfeed At 2Nd Transfer Section - Xerox Phaser 6115MFP Service Manual

Misfeed at 2nd Transfer Section

Phaser 6115MFP Multifunction Product Service Manual
For misfeed detection, the paper does not unblock the Registration Sensor
even after the lapse of a predetermined period of time following the activation
of the Registration Roller Solenoid. In some cases, the Fusing Paper Loop
Sensor is not blocked by the paper that has moved past the position where
the sensor is blocked.
For detection of paper, the Registration Sensor is blocked when the power
switch is turned ON, a cover is opened and closed, or a misfeed or
malfunction is reset. In some cases, the Fusing Paper Loop Sensor is blocked
when the power switch is turned ON, a cover is opened and closed, or a
misfeed or malfunction is reset.
Troubleshooting Reference Table
Applicable Parts
Registration Sensor,
PL4.17.2
Fusing Paper Loop Sensor,
PL4.17.2
Registration Roller Solenoid,
PL4.12.3
Engine Control Board,
PL4.19.15
Warning
To avoid the potential of electric shock, ensure the power to the printer is
off and the power cord is disconnected from the wall outlet prior to
performing each step of the following troubleshooting procedure.
Troubleshooting Procedure Table
Step Action and Questions
Check the Engine Control connectors P/
1
J14, P/J12, and P/J11. Are the
connectors seated properly.
2 Check the Registration Sensor at P/J12
(pin 3). Is the sensor operational?
3 Check the Fusing Paper Loop Sensor at
P/J14 (Pin 6). Is the sensor operational.
4 Check the Registration Roller Solenoid at
P/J11 (Pin 4). Is the solenoid
operational?
Replace the Engine Control Board
5
(page 8-57).
General Troubleshooting
Wiring and Plug/Jack References
Boards and Power Supplies Locator (page 1-14)
Sensors and Switches Locator (page 1-16)
Solenoids and Power Switch Locator
(page 1-17)
Engine Control Board to Solenoid and Sensor
Wiring (page 10-13)
Yes
Go to Step 2.
Go to Step 3.
Go to Step 4.
Go to Step 5.
Complete
No
Reseat the
connectors. If
the problem
persists, go to
Step 2.
Replace the
sensor
(page 8-116).
Replace the
sensor
(page 8-114).
Replace the
solenoid
(page 8-104).
4-5