Brush Effect or Blurred Image
Phaser 6115MFP Multifunction Product Service Manual
Troubleshooting Procedure Table (Continued)
Step Actions and Questions
3
Has the problem been
eliminated?
The image on the copy appears blurry or smeared.
Initial Actions
Verify the media used is supported by this printer.
Verify the media settings are correct at the Control Panel.
Troubleshooting Reference Table
Applicable
Parts
Imaging Unit,
PL4.15.9
Transfer Belt
Unit, PL4.15.5
Fusing Unit,
PL4.18.12
Troubleshooting Procedure Table
Step Actions and Questions
1
Check the media.
Is the paper damp or the
incorrect media for the
printer?
Yes
Complete
Example Print
Chrysanthemum x morifolium
Chrysanthemum x morifolium
Chrysanthemum x morifolium
Ink Smears Duplex
Yes
Replace with paper
that meets the
specifications for the
printer. If the problem
persists, go to Step 2.
Print-Quality Troubleshooting
No
Replace the following
units, listed in order,
until problem is
eliminated:
Engine Control
Board (page 8-57)
Fusing Unit
(page 8-36)
nthemum x
nthemum x
Chrysanthemum x morifolium
nthemum x
nthemum x
No
Go to Step 2.
Fuzzy Text
5-35