Uneven Density In The Feed Direction - Xerox Phaser 6115MFP Service Manual

Uneven Density in the Feed Direction

Phaser 6115MFP Multifunction Product Service Manual
Troubleshooting Procedure Table (Continued)
Step Actions and Questions
7 Check the paper path.
Is there a foreign object or
obstruction in the path?
Inspect the Fusing Unit.
8
Is the fusing entrance guide
plate or the separation claw
dirty or scratched?
Has the problem been
9
eliminated?
The density of the print along the length of the copy is inconsistent.
Initial Actions
Verify the media used is supported by this printer.
Verify the media settings are correct at the Control Panel.
Troubleshooting Reference Table
Applicable Parts
Imaging Unit, PL4.15.9
Transfer Belt Unit, PL4.15.5
High Voltage Unit, PL4.19.6
Laser Unit, PL4.14.1
Toner Cartridge (See consumables parts
list)
Print-Quality Troubleshooting
Yes No
Remove the object and Go to Step 8.
reprint the test sheet.
If the problem
persists, go to Step 8.
Clean the guide plate Go to Step 9.
and reprint the test
sheet. If the problem
persists, replace the
Fusing Unit
(page 8-36) and go to
Step 9.
Complete Replace the toner
cartridge (page 7-11)
and the Laser Unit
(page 8-15).
Example Print
Chrysanthemum x morifolium
Color Uneven or Wrong (Scan Direction)
5-19