Void Areas And White Spots - Xerox Phaser 6115MFP Service Manual

Void Areas and White Spots

Phaser 6115MFP Multifunction Product Service Manual
Missing spots or areas on the copy.
Initial Actions
Verify the media used is supported by this printer.
Verify the media settings are correct at the Control Panel.
Troubleshooting Reference Table
Applicable Parts
Imaging Unit,
PL4.15.9
Toner Cartridge
(See consumables
parts list)
Transfer Belt Unit,
PL4.15.5
Fusing Unit,
PL4.18.12
Troubleshooting Procedure Table
Step Actions and Questions
1 Inspect the Imaging Unit.
Is the outside of the surface
dirty?
2 Are there scratches on the
photo conductor surface?
Check the Transfer Belt
3
Unit. Are the mounting
shafts on the assembly fully
seated and installed
Is the transfer belt dirty or
4
scratched?
Example Print
Chrysanthemum x morifolium
Partial Band
Yes
Clean the surface. If
the problem persists,
go to Step 2.
Replace the Imaging
Unit.
Go to Step 4.
If the surface is dirty,
wipe the surface clean
with a soft cloth. If the
transfer belt is
scratched, replace the
unit (page 8-33).
Print-Quality Troubleshooting
Chrysanthemum x morifolium
Repeating Defects
No
Go to Step 2.
Go to Step 3.
Reseat and align
properly. If the problem
persists, go to Step 4.
Go to Step 5.
5-27