Fax/Transmission Error Codes - Xerox Phaser 6115MFP Service Manual

FAX/Transmission Error Codes

Phaser 6115MFP Multifunction Product Service Manual
Troubleshooting Procedure Table (Continued)
Step Action and Questions
2 Is the power source voltage being applied
to CN2 on DC Power Supply 1?
Communication Errors
Error caused by a problem of communication functioning. Five possible
causes of errors are:
1. Communication is discontinued by a machine error.
2. Communication is discontinued by a machine trouble.
3. Communication is discontinued by an error occurring at the destination
station.
4. Communication is discontinued by a protocol error.
5. ADF Error on trouble.
When communication is discontinued due to item 3 or 4, transmission is
retried. In other case, transmission is canceled without retry.
Error occurring during transmission
The transmission error before "Phase-B" performs redial according to the
redial interval of each country and the number of times.
The transmission error after "Phase-C" performs redial only one time.
Transmission is cancelled when an error occurs again. (can change in Soft
SW)
When an error occurs by ADF TX, transmission is canceled without redial.
(Picure here, Perhaps - with explanation).
Error Codes and Messages
Yes No
Replace the Replace the DC
Fusing Unit Power Supply 1
(page 8-36). (page 8-60).
3-35