Machine Is Not Energized - Xerox Phaser 6115MFP Service Manual

Error Codes and Messages

Machine is Not Energized

Applicable Status Code
Initial Actions
3-32
Machine is not energized at all (operational check)
N/A
Remove power from the system and reboot.
Print a test page.
Troubleshooting Reference Table
Applicable Parts
Power Switch, PL4.5.6
Engine Control Board,
PL4.19.15
DC Power Supply 1, PL4.19.3
Warning
To avoid the potential of electric shock, ensure the power to the printer is
off and the power cord is disconnected from the wall outlet prior to
performing each step of the following troubleshooting procedure.
Troubleshooting Procedure Table
Step Action and Questions
1 Is power source voltage being applied to
connector CN3 of the DC Power Supply
1?
Are fuses (F1 and F2) on the DC Power
2
Supply 1 conducting?
3 Is DC24V and DC5V being applied to PJ2
on the Engine Control Board?
4 Replace the Engine Control Board
(page 8-57).
Wiring and Plug/Jack References
Solenoids and Power Switch Locator
(page 1-17)
Engine Control Board to DC Power Wiring
(page 10-18)
Yes
Go to Step 2.
Go to Step 3.
Complete
Complete
Phaser 6115MFP Multifunction Product Service Manual
No
Check wiring
from the AC
power plug
through the
Power Switch.
If problem
persists, go to
Step 2.
Replace the DC
Power Supply 1
(page 8-60). If
problem
persists, go to
Step 3.
Go to Step 4.