Heating Roller Warmup Failure; Abnormally Low Heating Roller Temperature; 1Ah Abnormally High Heating Roller Temperature; 1Bh Faulty Thermistor - Xerox Phaser 6115MFP Service Manual

18H Heating Roller Warmup Failure
19H Abnormally Low Heating Roller Temperature

1AH Abnormally High Heating Roller Temperature

1BH Faulty Thermistor

Phaser 6115MFP Multifunction Product Service Manual
Troubleshooting Procedure Table (Continued)
Step Action and Questions
4 Check the Rack Positioning sensor at
PJ5, pin 11. Is the sensor on?
5 Replace the Engine Control Board
(page 8-57).
Applicable Status Code
18H:

Heating Roller Warmup Failure

Applicable Status Code
19H:

Abnormally Low Heating Roller Temperature

Applicable Status Code
1AH: Abnormally High Heating Roller Temperature
Faulty thermistor in the Fusing Unit.
Applicable Status Code
1BH: Faulty Thermistor
Initial Actions
Remove power from the system and reboot.
Print a test page.
Error Codes and Messages
Yes No
Go to Step 6. Replace the
sensor
(page 8-112). If
the problem
persists, go to
Step 6.
Complete.
3-23