Xerox Phaser 6115MFP Service Manual page 126

Error Codes and Messages
3-24
Troubleshooting Reference Table
Applicable Parts
Fusing Unit, PL4.18.12
Engine Control Board,
PL4.19.15
DC Power Supply 1, PL4.19.3
Warning
To avoid the potential of electric shock, ensure the power to the printer is
off and the power cord is disconnected from the wall outlet prior to
performing each step of the following troubleshooting procedure.
Troubleshooting Procedure Table
Step Action and Questions
1 Check the Fusing Unit for correct
installation.
Is the unit secured in position?
2 Check the connections between the
Fusing Unit (CN2), Engine Control Board
(P/J3 and P/J2)), and the power supply
(CN4, CN5, and CN6).
Are the connections correct?
3 Check the lever of the safety switch at
connector CN3.
Is the switch positioned properly and is
the connector seated properly.
Replace the Engine Control Board
4
(page 8-57).
Is the system operational?
5 Replace the DC Power Supply 1
(page 8-60).
Wiring and Plug/Jack References
Print Engine Wiring Map (page 10-12)
Engine Control Board to DC Power Wiring
(page 10-18)
Yes
Go to Step 2.
Go to Step 3.
Go to Step 4.
Complete
Complete
Phaser 6115MFP Multifunction Product Service Manual
No
Reinstall the
Fusing Unit
(page 8-36). If
the problem
persists, go to
Step 2.
Reseat the
connectors. If
the problem
persists, go to
Step 3.
Reposition the
switch and
reseat the
connector. If the
problem
persists, go to
Step 4.
Go to Step 5.