Xerox Phaser 6115MFP Service Manual page 7

Power Safety Precautions
Power Source
Disconnecting Power
Moving the Printer
Phaser 6115MFP Multifunction Product Service Manual
For 115 VAC printers, do not apply more than 135 volts RMS between the
supply conductors or between either supply conductor and ground. For 230
VAC printers, do not apply more than 254 volts RMS between the supply
conductors or between either supply conductor and ground. Use only the
specified power cord and connector. This manual assumes that the reader is
a qualified service technician.
Plug the three-wire power cord (with grounding prong) into a grounded AC
outlet only. If necessary, contact a licensed electrician to install a properly
grounded outlet. If the product loses its ground connection, contact with
conductive parts may cause an electrical shock. A protective ground
connection by way of the grounding conductor in the power cord is essential
for safe operation.
Warning
Turning the power off using the power switch does not completely de-
energize the printer. You must also disconnect the power cord from the
printer's AC inlet. Disconnect the power cord by pulling the plug, not the
cord.
Disconnect the power cord in the following cases:
if the power cord or plug is frayed or otherwise damaged,
if any liquid or foreign material is spilled into the product,
if the printer is exposed to any excess moisture,
if the printer is dropped or damaged,
if you suspect that the product needs servicing or repair,
whenever you clean the product.
Follow these guidelines to avoid injuring yourself or damaging the printer:
Do not place any food or liquids on the printer.
Turn off the printer and unplug all power cables before moving the printer.
v