Xerox Phaser 6115MFP Service Manual page 55

Phaser 6115MFP Multifunction Product Service Manual
Fusing Temperatures by Media
During printing, the roller set temperature varies according to the media as
listed in the following tables:
Fusing Temperatures for Monochrome
Media Type
Plain paper, letterhead
Plain paper, letterhead 257 mm
or less
Thick stock, postcards, labels
Transparencies
Envelopes
Glossy stock
* The temperature is controlled at 159 C if the system's interior temperature is 20 ×C or
more and relative humidity is 40% or higher.
Note
There is a Control Panel command which obtains environmental
temperature and humidity levels. However, this command is for internal
use only and not available from the service menus.
If the print cycle is started while the Temperature/Humidity Sensor indicates
an internal temperature of 20 C or more, control is returned back to one
having a control temperature of more than 60 ×C after five printed pages have
been produced.
Fusing Temperatures for Color (1-sided)
Media Type
Plain paper,
letterhead
Plain paper,
letterhead 257
mm or less
Thick stock,
postcards,
labels
Transparencies _
Envelopes
Glossy stock
Typical (°C)
169
169
169
169
194*
169
Roller temp at
Typical (°C)
warm-up start
60 C or less 189
More than 60 C 184
60 C or less 189
More than 60 C 184
_ 184
179
_ 194*
_ 190
Theory of Operation
Temperature/humidity
Sensor more than 20 °C
174
174
Temperature/
Temperature/
humidity
humidity Sensor
Sensor less
more than 20 °C
than 20 °C
194 189
194 184
194 189
194 184
190 185
2-11