Xerox Phaser 6115MFP Service Manual page 138
Color laser multifunction product
Hide thumbs
Also See for Phaser 6115MFP:
- User manual (219 pages) ,
- Setup manual (75 pages) ,
- Quick use manual (17 pages)
Table of Contents
Advertisement
Error Codes and Messages
3-36
FAX Error Codes
Code
Possible Causes of Error.
0001
No G3 signal received within 35 sec. in manual receive mode.
0003
Received DIS after sending DIS signal.
0004
Received DCN after sending DTC signal.
0006
Detect busy tone within receiving phase B.
0009
Can not receive any signal within 35 sec. in manual polling mode.
0010
Received DCN signal after sending DTC signal in polling RX.
0011
Can not receive any correct response after sending three DTC signals.
0012
Remote side Password does not match in polling RX/our side no file to be
polled.
0013
Can not receive carrier signal within 6 sec. after sending CFR in data phase
C.
0014
Can not receive T.30 signal after sending FTT signal.
0015
Line polarity change within receiving phase B to D.
0016
Receive DCN signal after sending PTT signal.
0017
Can not receive any response from remote side after sending type of
xxx_EOM signal.
0018
Can not detect energy within 6 sec. after sending FTT command.
0019
Received DCN signal after sending CFR signal.
001A
No energy on line over 6 sec. within phase C before any corrected ECM
frame.
001D
Detect flag but nothing after CFR.
0020
Can not correct frame within 6 sec., or in non-ECM mode, one decoding line
over 6 sec.
0021
File full.
0022
Owing to noise interference on the line, receiving side can't receive correct
data within specified time (no ECM).
002A
Line Problem
0030
Did not receive any signal within 6 sec.at phase D.
0031
Received incorrect signal at phase D (not EOP, MPS, EOM, DCS PPS_Q,
PPS_Q, etc.).
0032
Can not receive carrier within 6 sec. After sending MCF. Or RTP, RTN signal.
0033
Received DCN signal at phase D within pages (not last page).
0039
In non-ECM mode, when machine already received the data but next line
data doesn't receive within 13TX and RX machines both have different
"machine ID (FAX model ID)" code in RSD.
003F
Remote side TSI not programmed in machine one touch or speed dial
directory.
Phaser 6115MFP Multifunction Product Service Manual
Advertisement
Table of Contents
Troubleshooting
