Adf Cd Registration - Xerox Phaser 6115MFP Service Manual

ADF CD Registration

Phaser 6115MFP Multifunction Product Service Manual
6. Press the Menu/Select key, adjust the setting value using the +/- key, and
then press the Menu/Select key to validate the setting.
7.Repeat steps 4 through 6 until the length of line A falls within the specified
range.
8. If dimension A on the copy falls outside the specified range:
a. Increase the setting value if dimension A falls short of the specified
range.
b. Decrease the setting value if dimension A exceeds the specified
range.
Adjusts the image scan start position in the CD direction of the Auto
Document Feeder Unit.
When to Use:
When a new Auto Document Feeder Unit is mounted.
Specification:
20mm +/- 1.0mm
Adjustment Range:
The default setting is 0.00.
Adjustment Range: -5.00 (-5.00 mm) ~ "0.00 (0.00 mm)" ~ +5.00 (+5.00
mm)
Procedure:
1. Prepare a chart (A4S or 11 x 8 1/2S) by drawing a reference line on a
sheet of paper at a position 20 mm away from the edge as illustrated
below
2. Enter the SERVICE MODE.
3. Select [ADF CD REGIST] of [1 ADJUST] and press the Menu/Select key.
4. Load the test chart in the ADF and press the Start key.
Adjustments and Print Function Settings
Width A: 20 mm
s6115-362
6-51