Main Motor Malfunction - Xerox Phaser 6115MFP Service Manual

08H Main Motor Malfunction
Phaser 6115MFP Multifunction Product Service Manual
Main motor inoperative, noisy, or erratic.
Applicable Status Code
08H:

Main Motor Malfunction

Initial Actions
Check power cord and connections.
Power down and reboot the system.
Troubleshooting Reference Table
Applicable Parts
Main Motor, PL4.12.1
Engine Control Board,
PL4.19.15
DC Power Supply 1, PL4.19.3
Warning
To avoid the potential of electric shock, ensure the power to the printer is
off and the power cord is disconnected from the wall outlet prior to
performing each step of the following troubleshooting procedure.
Troubleshooting Procedure Table
Step Action and Questions
Check the Main Motor connector P/J8 to
1
the Engine Control Board for proper
connection.
Is the connector seated properly?
2 Check the Main Motor for proper
positioning.
Is the motor engaged with the gears?
Check the operation of the Main Motor.
3
Is the motor faulty?
Error Codes and Messages
Wiring and Plug/Jack References
Print Engine Board Plug/Jack Designators
(page 10-3)
Main Motor Plug/Jack Locator (page 10-16)
Engine Control Board to Main Motor and
Positioning Sensor Wiring (page 10-16)
Yes
Go to Step 2.
Go to Step 3.
Replace the
motor
(page 8-93). If
the problem
persists, go to
Step 4.
No
Reseat the
connector. If
the problem
persists, go to
Step 2.
Reseat the
motor drive
properly. If the
problem
persists, go to
Step 3.
Go to Step 4.
3-13