Table of Contents
Advertisement
APPENDIX 3 CABLE MANUFACTURING DRAWING
As a rule, most F
manufacture the required cables using the cable manufacturing drawings on the following pages as a
reference. Note that the cable-compatible connectors can be purchased from Mitsubishi.
If crimp tools are not available when manufacturing the power supply cable (R200, R220) and
communication cable (R211), the cables can be manufactured by soldering a wire and connector as
shown in the following procedure.
1. Carry out preparatory soldering onto the wire.
(Peel 3.5mm of the sheath.)
3. Lightly press down one side of the wire barrel
using radio pliers.
Radio pliers
5. Firmly press down the sheath retainer in the
same manner as the wire barrel.
Sheath retainer
7. Lastly, insert the soldered contact with wire
into the housing.
Downloaded from
ManualsNet.com
APPENDIX 3 CABLE MANUFACTURING DRAWINGS
/R
Soldering iron
Wire
Solder
This is a barrier to prevent
Wire barrel
incorrect insertion. Do not bend.
Pay attention to the insertion direction.
search engine
cables used with this product are not sold by Mitsubishi. Thus,
2. Insert the wire into the contact. Hold
4. Firmly press down the other side of the
6. Apply the soldering iron, and melt the
I-23
the sheath retainer.
wire barrel.
(Press firmly enough that the wire will
not come out when pulled lightly.)
preparatory solder inside.
Better results will be achieved if an
additional, small amount of solder is
applied.
Soldering iron
Contact section
Be careful that the solder does not
flow into the contact section.
Contact
Advertisement
Table of Contents
