Loading Transparencies In The Oversized High Capacity Feeder (Ohcf / Trays 6 And 7) - Xerox Versant 80 Press User Manual

• If a jam occurs while running tabbed sets, cancel the job and start again.
1. After programming your tab job at the print server, select the appropriate and
matching tab stock for your print job.
2. Pull out the tray slowly until it stops.
3. Fan the tab paper before loading into the tray.
4. Load the tab stock LEF (portrait) and align the straight edge of the tab stock against
the right edge of the tray (tabs to the left or trailing edge). For single straight collated
tabs, the first blank tab cutout in the stack will be toward the front of the tray. For
single reverse collated tabs, the first blank tab cutout in the stack will be toward the
rear of the tray.
Tab stock is loaded so the straight edge of the stock is in the feed direction. Also, you
can only load the tab stock LEF.
5. Adjust the paper guides by pressing in the guide release and carefully moving the
Edge Guide until it lightly touches the edge of the stock in the tray.
Do not load materials above the MAX line located on the rear Edge Guide.
6. Gently push in the tray until it comes to a stop.
The Paper Tray settings/Tray Properties window displays on the UG.
7. From the Paper Tray settings/Tray Properties window, confirm the correct tray to
which it is printing and other information, including size (9 x 11 inches), type (precut
tab), and, if necessary, paper curl and/or alignment option.
8. Select Confirm or OK to save the information and close the Paper Tray settings/Tray
Properties window.
Loading Transparencies in the Oversized High Capacity Feeder
(OHCF / Trays 6 and 7)
Read these tips before using transparencies:
• Do not use transparencies with the white side strip (either permanent or removable).
• Do not mix paper and transparencies in a tray. Jams may occur.
• Do not load more than 100 transparencies in a paper tray at one time.
• Load 8.5 x 11 in (A4) transparencies long edge feed only (landscape).
1. Select the appropriate paper stock for your print job.
2. Pull out the tray slowly until it stops.
3. Fan the transparencies to stop them from sticking together before loading into the
tray.
4. Load transparencies LEF on top of a small stack of same-size paper and align the
strip edge of the transparency against the right edge of the paper tray, with the side
to be printed on facing down.
® ®
Xerox Versant 80 Press
User Guide
Paper and Media
3-13