Loading Pre-Drilled Stock In The Bypass (Tray 5); Loading Envelopes In The Bypass (Tray 5) - Xerox Versant 80 Press User Manual

8. From the Paper Tray settings/Tray Properties window, enter the correct paper
information, including size, type, weight and, if necessary, paper curl and/or alignment
option.
9. Select Confirm or OK to save the information and close the Paper Tray settings/Tray
Properties window.

Loading Pre-drilled Stock in the Bypass (Tray 5)

1. Gently extend the Bypass tray (Tray 5) as necessary to accommodate the paper.
2. Hold the center of the paper guides and slide them to the desired paper size.
3. Select the appropriate paper stock for your print/copy job.
4. Fan the sheets before loading them into the tray.
5. Insert the pre-drilled stock into the tray in the LEF direction with the holes to the
right.
6. Continue to insert the paper or media into the tray until it stops.
7. Adjust the paper guides so that they touch the edges of the stack.
8. From the Paper Tray settings/Tray Properties window, enter the correct paper
information, including size, type, weight and, if necessary, paper curl and/or alignment
option.
9. Select Confirm or OK to save the information and close the Paper Tray settings/Tray
Properties window.

Loading Envelopes in the Bypass (Tray 5)

Note
It is recommended that you print envelopes from the Bypass/Tray 5 only. Optional Trays
6 and 7 (OHCF) can be used if the Postcard Bracket is mounted and the stack height is
limited to no more than 200 envelopes.
When setting up your print job, follow the steps below to define the custom paper settings
at the Paper Tray settings/Tray Properties window and assign this stock to Tray 5. With
the flap closed, measure the height and width of the envelope.
The following envelope sizes are supported. Other sizes can be used but performance is
not guaranteed.
• C4 (229 x 324 mm) Short Edge Feed or Long Edge Feed
• C5 (162 x 229 mm) Short Edge Feed or Long Edge Feed
• #10 (4.125 x 9.5 inches) Short Edge Feed
1. Always load envelopes with the flaps closed.
Do not use padded envelopes.
2. When loading in the SEF direction, place the flaps facing the back of the press. When
loading in the LEF direction, place the flaps facing the lead edge.
3. When submitting your network print file, select Custom Paper as the Paper Type.
Enter the dimensions of the envelope.
® ®
Xerox Versant 80 Press
User Guide
Paper and Media
3-7