Xerox Versant 80 Press User Manual page 296

GBC AdvancedPunch Pro
4. Continue to pull the handle until the Punch Die Set is fully removed, supporting it
with both hands.
5. Properly store the removed die set in the die set storage area of the AdvancedPunch
Pro.
This keeps it away from dust, dirt, and accidental falls from the edge of counters.
6. Select the desired Punch Die Set for your new job and slide it into the Punch Die Set
slot. Push the die set firmly until the Die Stop feature contacts the round magnet.
This is critical in ensuring the proper position of the die set.
7. Grasp the handle and rotate it in the counter-clockwise direction until the latch is
fully engaged, as shown on the die set label.
Warning
Possible pinch-point hazard. When installing the punch die set, always keep fingers
and other body parts out of the unit's die set slot and away from all areas of the
punch die set, except for the finger hole in the die set. Failure to follow these
precautions may result in injury.
8. Close the AdvancedPunch Pro Front Door.
9. Proceed with your printing and punching job.
Note
Please note that when using a new die set, some oil will be present around the punched
holes on the sheet. After punching 25 to 50 sheets the die will no longer leave oil on
the sheets. It is recommended that a short test print job be run after installing a new
die or a die that has recently been oiled.
Related Topics:
22-16
® ®
Xerox Versant 80 Press
User Guide