Fault Codes - Squarefold Trimmer Module - Xerox Versant 80 Press User Manual

Fault code Possible cause
024-980 The stacker tay is full
024-981 The top tray is full
024-982 The Finisher stacker tray
lower safety warning is on
024-983 The Finisher Booklet tray is
full
024-984, 024-985 The Booklet stapler low staple
signal is on
024-987, 024-988 The Booklet folder tray is full
047-320 A communication error has
occurred with the Finisher
112-700 The Punch Waste Container
is full or near full
116-790 The settings for stapling are
canceled and prints the data
124-705 The settings for punching are
canceled
124-706 The settings for folding are
canceled
124-709 The number of pages exceeds
the number of pages that can
be stapled

Fault Codes - SquareFold Trimmer Module

If a fault occurs in the SquareFold Trimmer Module, a fault message displays. The
following table provides a list of fault codes for this finisher module and of related fault
codes.
Note
The top covers cannot be opened during normal operation or when the press is idle. The
covers can be opened only when an indicator is lit and a fault occurs within the finisher
module. For indicator details, refer to the control panel information.
® ®
Xerox Versant 80 Press
User Guide
Press Problem Solving
Recommended solution
Remove all paper from the stacker tray.
Remove all paper from the Finisher top
tray.
Remove all paper from the stacker tray
and remove any other obstructions.
Remove all paper from the Booklet tray.
Remove all paper from the Booklet tray.
Remove all paper fromthe tray. Set the
output tray for three-fold. Check that the
folder tray is correctly attached and set.
Power Off/On the press. Resend the print
job if needed. If fault persists, contact
Customer Support Center.
Remove and empty the waste container
and then reinstall it completely.
Confirm the staple position and try to
print again.
Confirm the punching position and try to
print again.
Confirm the folding settings and try to
print again.
Decrease the number of pages, or cancel
the stapling settings. Resend the print job.
14-31