Ohcf Problem Solving (Trays 6 And 7); Fault Codes - Oversized High Capacity Feeder (Trays 6 And / Or 7) - Xerox Versant 80 Press User Manual

1- or 2-Tray Oversized High Capacity Feeder (OHCF / Trays 6 and 7)
f) Select the item (HCF) that corresponds with the newly-replaced components.
g) Select Reset Current Value. The system resets the HFSI to 0.
14. Exit administrator mode by pressing the Log In/Out button on the UI.
When prompted, select Logout.

OHCF Problem Solving (Trays 6 and 7)

Fault Codes - Oversized High Capacity Feeder (Trays 6 and / or 7)

The OHCF fault codes below may pertain to a specific tray of the feeder. If you experience
these fault codes frequently, you should follow the procedure on how to replace the
feed rolls (Replacing the OHCF Bypass Tray Feed Rolls (Trays 6 and 7)
the OHCF Feed Rolls (Trays 6 and
Fault Area Fault Code
Bypass (Tray 5) 078-105,
078-120,
078-125,
078-126,
078-127
Bypass Tray 078-110
Bypass Tray 078-111
17-6
7)).
Possible Cause Recommended Solution
Repetitive misfeeds or 1.
multifeeds
2.
3.
4.
Pre-registration sensor jam Perform the following in this order:
during paper transporta-
1.
tion from Bypass Tray
2.
Regi sensor not turned on
fault during paper trans-
3.
portation from Bypass
Tray
4.
and Replacing
Fan the paper to eliminate
paper adhesion (especially
in high humidity or high
temperature environments).
Clean the Bypass Tray feed,
retard, and nudger rolls with
a damp cloth.
Replace feed rolls (feed, re-
tard, nudger); refer to Repla-
cing the OHCF Bypass Tray
Feed Rolls (Trays 6 and 7).
If problem persists, Call for
service.
Remove or clear any
jammed paper.
Replace and fan the paper
in tray.
Power Off / On the press.
If problem still persists,
contact the Customer Sup-
port Center.
® ®
Xerox Versant 80 Press
User Guide