Loading Pre-Drilled Stock Into The Ohcf (Trays 8 And 9) - Xerox Versant 80 Press User Manual

Paper and Media
4. Load transparencies LEF on top of a small stack of same-size paper and align the
strip edge of the transparency against the right edge of the paper tray, with the side
to be printed on facing down.
5. Adjust the paper guides by pressing in the guide release and carefully moving the
Edge Guide until it lightly touches the edge of the material in the tray.
Do not load materials above the MAX line located on the rear Edge Guide.
6. Gently push in the tray until it comes to a stop.
The Paper Tray Properties window displays from the Stock Library Manager on the
print server. The Stock Library Manager is available from the print server only and
not at the press.
7. From the Tray Properties window, confirm that the correct stock information for
transparencies, such as size, type, weight, are selected.
8. Select OK to save the information and close the Tray Properties window.

Loading Pre-drilled Stock into the OHCF (Trays 8 and 9)

1. Select the appropriate paper stock for your print job.
2. Pull out the tray slowly until it stops.
3. Open the ream of paper with the seam side facing up.
4. Fan the sheets before loading them into the tray.
5. Load and register the paper against the right side of the tray for LEF direction.
6. Load and register the paper against the right side of the tray as depicted below for
SEF direction.
7. Adjust the paper guides by pressing in the guide release and carefully moving the
Edge Guide until it lightly touches the edge of the stock in the tray.
Do not load materials above the MAX line located on the rear Edge Guide.
8. Gently push in the tray until it comes to a stop.
3-20
® ®
Xerox Versant 80 Press
User Guide