Pre-Punch Job Checkpoints; Changing Settings On The Advancedpunch Pro - Xerox Versant 80 Press User Manual

GBC AdvancedPunch Pro

Pre-Punch Job Checkpoints

Before using the punching feature for any print or copy jobs, perform the following
checkpoints.
1. Ensure that there are no fault indicators / messages on the User Display Panel of the
AdvancedPunch Pro.
2. If there is a fault indicator / message, then correct the fault prior to starting the punch
job.
Note
The AdvancedPunch Pro will not operate in punch mode if any fault indicators /
messages are displayed on the User Display Panel.
3. Prior to starting the punch job, ensure that the punch die installed in the
AdvancedPunch Pro is the correct die / hole pattern for the job.
4. If the die set is not the correct one, then replace it at this time.
5. Before using the punching feature for any print or copy jobs, ensure that the correct
Punch Mode is selected on the AdvancedPunch Pro.
6. For Network Print jobs, select the desired punching feature from File > Print > Printer
Properties.
7. For Copy jobs, select the desired punching feature from the press User Interface /
Control Panel.
a) From the main home screen on the press User Interface / Control Panel, select
the Copy feature.
b) Select Copy Output to enter the Hole Punch & More menu.
c) From the Hole Punch & More menu select the AdvancedPunch Pro option from
the hole punch column.
d) Select Save.
The main Copy feature displays, and the copy job will print using the select punch
option.
Related Topics:
Layout of the User Display Panel
Changing Die Sets in the AdvancedPunch Pro (Removing / Installing)
AdvancedPunch Pro General Problems

Changing Settings on the AdvancedPunch Pro

1. From the AdvancedPunch Pro User Display Panel, press either the Up or Down button
to enter the Main Menu.
2. From the Main Menu, select Settings by pressing Enter button on the User Display
Panel.
3. From Settings, select the desired feature.
• Punch Mode
• Backgage Depth Setting
22-14
® ®
Xerox Versant 80 Press
User Guide