Gbc Advancedpunch Problem Solving; Fault Codes - Gbc Advancedpunch; Gbc Advancedpunch General Problems - Xerox Versant 80 Press User Manual

GBC AdvancedPunch Problem Solving

Fault Codes - GBC AdvancedPunch

Fault codes for the GBC AdvancedPunch are displayed on the press User Interface /
Control Panel as an AdvancedPunch fault code.
Fault Code Cause
040-100 Jam is detected in the Advanced-
040-101 Punch.
040-900
040-901
040-300 Front door of the Advanced-
Punch is not closed.
040-940 The punch die set is missing or
not fully installed.
040-941 Punch container is missing or
not fully installed.
040-942 Punch container is full.
140-700 Punch container is near full.

GBC AdvancedPunch General Problems

Cause
No power or will not punch
® ®
Xerox Versant 80 Press
User Guide
Remedy
1. Open AdvancedPunch front door
and look for a paper jam.
2. Remove any paper jam.
3. Close front door.
Close front door of the AdvancedPunch.
Install punch die set or fully insert it; close
front door.
Install and / or fully insert punch container;
close front door.
Empty punch container and then reinstall
it.
Empty punch container and then reinstall
it.
Remedy
1. Check that the power cord is attached to the
back of the unit.
2. Ensure that the power cord is plugged into the
wall outlet.
3. Ensure that the AdvancedPunch power is
switched on.
4. If the problem continues, contact the Custom-
er Support Center.
GBC AdvancedPunch
21-7