Chapter 4 Procedures Before Operation - Mitsubishi Electric CC-Link IE-NZ2GNSS2-8D User Manual

4
PROCEDURES BEFORE OPERATION
This chapter describes the procedures before operation.
Consideration of system configuration
1.
Determine a safety category required for configuring the safety system.
2.
Determine function wiring required for configuring the safety system.
Safety remote I/O module installation, wiring, and parameter setting
1.
IP address setting switch setting
Set the fourth octet of IP address of the safety remote I/O module.
Page 37 IP Address Setting Switch Setting
2.
Attaching
Mount the safety remote I/O module on a DIN rail.
Page 41 Mounting the modules on a DIN rail
3.
Wiring
Connect the power supply, Ethernet cables, and external devices to the safety remote I/O module.
Page 44 Wiring of Terminal Block for Module Power Supply and FG
Page 47 Wiring of Ethernet Cable
Page 49 Wiring of External Device and I/O Terminal Block
4.
Network parameter setting
Set the network parameters.
 User's manual for the master station used
5.
Parameter setting
Set the module parameters of the safety remote I/O module.
Page 57 Parameter Setting
6.
Safety module validation
Enable the module parameters of the safety remote I/O module.
Page 65 Safety Communication Setting
To replace the safety remote I/O module, follow the procedure described below:
• Export the parameter settings. Exporting is not necessary when slave station parameter automatic setting is
enabled.
• Power off the safety remote I/O module and remove it.
• Prepare a new safety remote I/O module and perform the procedure from step 1 to step 6. At that time,
import the parameter settings. The setting of the IP address setting switch must be the same as that of the
safety remote I/O module before it was replaced. Step 5 is not necessary when slave station parameter
automatic setting is enabled.
4 PROCEDURES BEFORE OPERATION
32