Omron ZW-8000 Series User Manual page 106

3
Select data to monitor the trend for.
Set data to monitor the trend for.
The types of data that can be set are as follows.
Item
Target data
4
Set the logging sampling interval.
Set the logging sampling interval for the target data.
Item
Sampling setting
* 1: The types of values that can be set vary depending on the measurement cycle being set.
Values outside the following range cannot be set.
0.5 [ms]/Measuring cycle [ms] to 100 [ms]/Measuring cycle [ms]
5
Click the Start icon (
When the sampling starts, the sampled data is displayed in the graph.
Note
You can also specify the timing (start trigger, end trigger) for the graph display.
6
Click the End icon (
When the sampling ends, the graph display stops too.
104
Displaying measured values in graphs
Setting item Description
OUT1 Measurement results assigned to OUT1
OUT2 Measurement results assigned to OUT2
OUT3 Measurement results assigned to OUT3
OUT4 Measurement results assigned to OUT4
TIMING TIMING input signal (parallel I/O)
ZERO ZERO input signal (parallel I/O)
BUSY BUSY output signal (parallel I/O)
ENABLE ENABLE output signal (parallel I/O)
HIGH HIGH output signal (parallel I/O)
PASS PASS output signal (parallel I/O)
LOW LOW output signal (parallel I/O)
TASKSTAT TASKSTAT output signal (parallel I/O)
LOGGING LOGGING input signal (parallel I/O)
LOGSTAT LOGSTAT output signal (parallel I/O)
LOGERR LOGERR output signal (parallel I/O)
STABILITY STABILITY output signal (parallel I/O)
RESET RESET output signal (ParallelI/O)
LIGHT_OFF LIGHT_OFF input signal (parallel I/O)
BUFFER_ERR Turn ON when dropping occurs.
Dropping may occur depending on the load factor of PC when acquiring
data from ZW-8000/7000/5000 series. If dropping occurs, increase the
arguments of logging.
Setting item Range
Logging sampling interval * 1
) to start the sampling.
) to end the sampling.
Description
Set the sampling interval for the target data.
ZW-8000/7000/5000
User's Manual