Omron ZW-8000 Series User Manual page 250

Performing 2-point Scaling
Performing 2-point Scaling p.146
Operating procedure
Steps Key operation
1 to 5 For moving to "SCALE", see steps 1 to 5 in p.246.
6
7
8
9
10
11
12
13
248
Setting the Output Conditions
Display Description
Select "AUTO" as the scaling type.
The current setting value is displayed on the sub-display.
Press
Select "AUTO" and press the
Press the
Press the
Set the measured value of point 1.
The current measured value is displayed on the main display and the
current setting value is displayed on the sub-display.
To edit numerical values, use the
Enter the setting value and then press the
Press the
Set the measured value of point 2.
To edit numerical values, use the
Enter the setting value and then press the
"OK/CAN" is displayed on the sub-display.
Press the
Press and hold the
RUN mode.
To save the setting, refer to "7-3 Functions of Operating Keys"
(p.222).
/ key to enter editing mode and the sub-display blinks.
key.
/ keys to select "2PT" and press the
key when the main display shows "POINT1".
/
key when the main display shows "POINT2".
/
key to execute scaling or
key for two seconds or more to enter the
key.
/ / keys.
key.
/ / keys.
key.
key to cancel.
ZW-8000/7000/5000
User's Manual