Table of Contents
Advertisement
7-11 Setting the System
Display/set the system environment.
Checking Information
Display the set measuring cycle and information of the Sensor Controller and Sensor Head.
Checking the Information of the Sensor p.192
As an example, here is an explanation of the procedure for displaying the serial No. of the Sensor Head.
Operating procedure
Steps
Key operation
1
2
3
4
5
6
7
268
Setting the System
Display
-
Description
Press and hold the
key for two seconds or more to enter the
FUNC mode.
To save the setting, refer to "7-3 Functions of Operating Keys"
(p.222)
Press the
/
keys to select "SYSTEM" and press the
key.
Select the information to display.
C.INFO: CONTROLLER INFORMATION
H.INFO: SENSOR HEAD INFORMATION
In this example, press the
/
press the
key.
When the Controller information and Sensor Head information have
been changed, select the additional information to display:
VER: Controller version information
MAC.ADR: Controller MAC address
MODEL: Sensor Head model information
SER.NO: Sensor Head serial No.
In this example, press the
/
press the
key.
"SER.1" is displayed on the main display and the higher-order digit of
the serial No. is displayed on the sub-display.
When the
/
key is pressed, "SER.2" is displayed on the
main display and the lower-order digit of the serial No. is displayed
on the sub-display.
Press and hold the
key for two seconds or more to enter the
RUN mode.
To save the setting, refer to "7-3 Functions of Operating Keys"
(p.222).
keys, select "H.INFO" and
keys, select "SER.NO" and
ZW-8000/7000/5000
User's Manual
Advertisement
Table of Contents
Troubleshooting
