Omron ZW-8000 Series User Manual page 117

1
Set the logging conditions.
Enter the [Data interval], [Number of logging
data], and select the stored output data and
whether to clear the stored logging data when
logging starts.
Item Setting item
Data logging Data interval
conditions
Number of
logging data
OUT1
OUT2
OUT3
OUT4
Logging start
when logging is
cleared
2
Click the [Logging start] button to start internal logging.
A confirmation message is displayed. Click [Yes] to start internal logging.
When the label insert mode is OFF, the internal logging data is automatically cleared before internal
logging is started.
Once internal logging starts, another internal logging cannot be started until it ends.
If you want to stop logging partway, press the "Cancel" button of the following pop-up that is displayed
during logging.
• Label insert mode not supported/
Label insert mode: OFF
ZW-8000/7000/5000
User's Manual
Range Description
1 to 1000 Set the data storage interval.
If "1" is set , all measured data is stored, and "2" is set, one
measurement value is stored every two measurement.
If 0 is set, data is saved only when the hold value is applied.
1 to 2000000 Set the number of data to store for the data that is assigned
to each OUT.
OFF/ON Set whether to store the measurement results for OUT1.
OFF/ON Set whether to store the measurement results for OUT2.
OFF/ON Set whether to store the measurement results for OUT3.
OFF/ON Set whether to store the measurement results for OUT4.
Set whether to clear previously logged data when logging
OFF/ON
starts.
• Label insert mode: ON
Performing internal logging
115