Omron ZW-8000 Series User Manual page 82

Class Name
Parallel ZERO input
input
RESET input
TIMING input
LIGHT OFF input
BANK_SEL input
LOGGING input
SYNC/TRIG input
80
Wiring
Description
This is used to execute and clear a zero reset.
This resets all executing measurements and outputs.
While a RESET is being input, judgment output conforms to the non-measurement setting.
If this RESET input switches ON while the hold function is used, the state in effect before
the hold function was set will be restored.
This is a signal input from an external device that is used to time the hold function with the
continuous measurement function enabled.
This is a signal input from an external device that is used to time the measurement with the
trigger measurement function enabled.
This LIGHT-OFF signal puts out the white LED used for measuring.
While LIGHT-OFF is being input, the analog output, binary output, and judgment output
conform to the non-measurement setting.
This is used for switching banks.
Specify the bank number in combinations of BANK_SEL1, 2 and 3.
However, if the bank mode is set to "JUDGMENT", the bank cannot be switched at the
external signal input because the number of banks increases to 32.
Bank Number BANK_SEL1
BANK1 OFF
BANK2 ON
BANK3 OFF
BANK4 ON
BANK5 OFF
BANK6 ON
BANK7 OFF
BANK8 ON
This is used to start and end internal logging.
In the internal/PDO synchronized mode, this is a signal input (SYNC input) used in order
for the multiple ZWs to perform synchronization of measurements (image capture) at the
same time.
In the external synchronous measurement mode, this is a signal input (TRIG input) used in
order to decide the measurement (image capture) timing.
BANK_SEL2 BANK_SEL3
OFF OFF
OFF OFF
ON OFF
ON OFF
OFF ON
OFF ON
ON ON
ON ON
ZW-8000/7000/5000
User's Manual