Omron ZW-8000 Series User Manual page 252

Performing Thickness Scaling
Performing Thickness Scaling p.151
Operating procedure
Steps Key operation
1 to 5 For moving to "SCALE", see steps 1 to 5 in p.246.
6
7
8
9
250
Setting the Output Conditions
Display Description
Select "THICK" as the scaling type.
The current setting value is displayed on the sub-display.
Press
Select "THICK" and press the
The current measured value is displayed on the main display and the
current setting value is displayed on the sub-display.
Press
blinks.
To edit numerical values, use the
Enter the setting value and then press the
"OK/CAN" is displayed on the sub-display.
When continuing to set the next point measurement value, press the
Press and hold the
RUN mode.
To save the setting, refer to "7-3 Functions of Operating Keys"
(p.222).
/ key to enter editing mode and the sub-display blinks.
key.
key to enter the editing mode, and the sub-display
/
key. When ending all point settings, press the
key for two seconds or more to enter the
/ / keys.
key.
key.
ZW-8000/7000/5000
User's Manual