Omron ZW-8000 Series User Manual page 259

Setting the Offset
Setting the Offset p.170
As an example, here is an explanation of the procedure for selecting the "10 mm" reference value setting.
Operating procedure
Steps Key operation
1 to 5 For moving to "ZERO", see steps 1 to 5 in p.256.
6
7
8
9
ZW-8000/7000/5000
User's Manual
Display Description
Press the
key.
Change the offset value.
The current setting value is displayed on the sub-display.
Press
blinks.
To edit numerical values, use the
In this example, input "10", then press the
The decimal point is displayed.
Press the
Determine the decimal point and then press the
Press and hold the
RUN mode.
To save the setting, refer to "7-3 Functions of Operating Keys"
(p.222).
/ keys to select "OFFSET" and press the
key to enter the editing mode, and the sub-display
/ /
/ key to move the decimal point.
key for two seconds or more to enter the
Setting the Output Conditions
/ keys.
key.
key.
257