Remove The Fiber Cable - Omron ZW-8000 Series User Manual

• Be sure to use a Sensor Head and Calibration ROM with the same serial number.
• A pair with different serial numbers cannot operate normally.
• Make sure to initialize the Sensor Controller when connecting a different type Sensor Head from that which was
connected the previous time the Sensor Controller was launched.
For the initialization method, see below.
Initializing Settings p.187
Initializing Settings p.271

Remove the Fiber cable

For ZW-8000/7000 Series
1
When you remove the fiber cable, make sure to have the black part of the connector which indi-
cated.
Have the fiber connector (black part) illustrated under figure, and then pull out the direction of the arrow.
ZW-8000 Series
Important
If you have the bush section of Fiber cable, that part may be out of place. Make sure to have the fiber
connector section.
ZW-8000/7000/5000
User's Manual
ZW-7000 Series
Basic Operations for Displaying Measurement Results
39