Event Code List - Mitsubishi Electric MELSEC iQ-R Series User Manual

Event code list

The following table shows the event code list of a recorder module.
Event Event type
code
00170 System
00171 System
00C00 System
00C01 System
20400 Operation
20401 Operation
24020 Operation
24021 Operation
24030 Operation
24031 Operation
24040 Operation
24044 Operation
24050 Operation
24051 Operation
2A010 Operation
2A030 Operation
2A032 Operation
2A040 Operation
2A050 Operation
2A051 Operation
5 TROUBLESHOOTING
176
5.6 Recorder Module
Event Overview
classificatio
n
Information Co-recording trigger sending
Information Co-recording trigger receiving
Warning Recording Start with Program Inconsistency
Warning Program Inconsistency during Recording
Operation
Information Firmware update succeeded(Recorder module)
Information Firmware update failed(Recorder module)
Information Recording Operation Start
Information Recording Operation Stop
Information File Saving Trigger Establishment
Information Recording Files Saving Completion
Information Error Clear
Information INFO LED Off
Information Project Data Saving Start
Information Project Data Saving Completion
Warning SD Memory Card Initialization
Warning Recording Files Saving Completion
Warning Recording Files Saving Completion
Warning Recording Files Saving Completion
Warning Project Data Saving Failure
Warning Project Data Saving Failure
Cause
The co-recording trigger has been sent.
The co-recording trigger has been received.
It is different from the project (program, FB/FUN) at
the recording setting because a program file or FB/
FUN file in the CPU module was changed during
recording operation.
When a device/label that is not a sampling target is
added, the added device/label cannot be saved and
replayed.
It is different from the project (program, FB/FUN) at
the recording setting because a program file or FB/
FUN file in the CPU module was changed during
recording operation.
When a device/label that is not a sampling target is
added, the added device/label cannot be saved and
replayed.
The firmware of the Recorder module was
successfully updated.
The firmware update of the Recorder module failed.
The recording operation has been started.
The recording operation has been stopped.
The file saving trigger has been established.
Saving the recording files has been completed.
Errors have been cleared.
INFO LED has been turned off.
Saving the project data has been started.
Saving the project data has been completed.
The SD memory card has been initialized.
• Saving the recording files has been completed.
• Failed to save the event history file.
• Saving the recording files has been completed.
• The sampled device and label data have exceeded
the size that can be stored in the recording buffer.
• Please set a sufficient size for the recording buffer
in the basic settings of the module parameter.
• Please set a shorter saving period before and after
the file saving trigger or saving period after the
recording startup trigger in the saving period
setting of the recording setting.
• Please reduce some device and label data to be
stored in the Device/Label sampling target setting
of the recording settings.
• Saving the recording files has been completed.
• Failed to save some video data.
Failed to save the project data because accessing
the SD memory card failed due to any one of the
following causes.
• The SD memory card is not inserted.
• The access status of the SD memory card is the
unmount state.
• The write-protect switch of the SD memory card is
enabled.
Failed to save the project data to the SD memory
card due to any one of the following causes.
• The free space in the SD memory card is
insufficient.
• An error of the SD memory card has been
detected.