Mitsubishi Electric MELSEC iQ-R Series User Manual page 150

Precautions
• When changing the configuration or start I/O number of a camera recorder module, the status cannot be monitored properly
and the operation is not guaranteed. The settings in the "Video Data Receiving Target Setting" screen of the recording
setting must also be changed.
Page 141 Video Data Receiving Target Setting
• If this screen is opened before the communication between a network camera and a camera recorder module is completed,
the manufacturer name and model name may not be displayed in the camera detailed information. To display them, wait a
few minutes until the communication is completed, and then open this screen again.
Note that the manufacturer name and model name are always blank if a network camera is not connected.
• Even when deleting a recording setting in the "Online Data Operation" screen, the setting may remain displayed in this
screen. It is updated by opening this screen again after resetting a CPU module and switching it to RUN.
Status of a network camera
A displayed state is determined by the combination of values in the following buffer memories of a camera recorder module.
• Network camera connection status (Un\G34300, Un\G34800, Un\G35300, Un\G35800) (Page 282 Network camera
status area (Un\G34000 to 37999))
• Camera recording status (Un\G1650 to 1653, Un\G1850 to 1853, Un\G2050 to 2053, Un\G2250 to 2253) (Page 271
Recording status area (Un\G1500 to 3199))
Displayed state
Stopped
Preparing
Operating
Saving Trigger Establishment
Saving
No Setting
Disconnected
Retrying
No Setting
4 RECORDING MONITOR
148
4.2 Camera Monitor Screen
Buffer memory
Network camera connection status
Connected
Disconnected
Retrying
No setting
Camera recording status
Stopped
Preparing
Operating
File saving trigger satisfied
Saving
No setting
