Mitsubishi Electric MELSEC iQ-R Series User Manual page 193

Error code Error name
1D81H Network Camera Video Rotation
Angle Setting Error
1D90H Network Camera SNTP Client
Unsupported Error
1DB0H Network Camera Time
Synchronization Setting Error
1DC0H Network Camera
Communication Start Error
1DE0H Network Camera Video Data
Storage Start Error
1DF1H Network Camera
Communication Error
1E10H Recording Files (Video Data)
Saving Failure
1E11H Recording Files (Video Data)
Saving Failure
1E71H Network Camera Setting Error
1E72H Network Camera
Communication Error
Error description
The video rotation angle of the target
network camera is incorrect.
The target network camera does not support
the SNTP client function.
Failed to set the time synchronization of the
network camera.
Failed to communicate with the target
network camera.
Failed to store video data of the target
network camera.
Unable to connect with the target network
camera.
Because the video data of the target network
camera has never been stored in the saving
target period, the recording files (video data)
were not saved.
Failed to save the video file of the target
network camera.
A setting error has occurred in the target
network camera.
An error has occurred in the communication
with the target network camera.
Corrective action
• Please set the video rotation angle that can be set for
the network camera.
• Please enable the simple setting mode of the module
extension parameter with the engineering tool, then
execute writing.
Please use a network camera that supports the SNTP
client function.
• Please check the operation status of the target
network camera.
• Please check if the connection cable is not
disconnected.
• Please check the time in the programmable
controller.
• Please check the operation status of the target
network camera.
• Please check if the connection cable is not
disconnected.
• Please check the operation status of the target
network camera.
• Please check if the connection cable is not
disconnected.
• Please check the operation status of the target
network camera.
• Please check if the connection cable is not
disconnected.
• The line may be busy with packets. Please consult
the network administrator of the connected LAN.
• Please check that the time of the target network
camera and the camera recorder module are
synchronized.
• Please check the status receiving the video data from
the target network camera.
• If the load on the network is high, please reduce the
load by modifying the module extended parameter.
• If the error due to communication with the network
camera is set to be categorized as "warning" in the
module parameters, please check the event code
and take the corrective action.
• Set the operation at video data saving to "Video data
receiving takes priority" in the module parameters.
• If the load on the network is high, please reduce the
load by modifying the module extended parameter.
• Please restart the network camera.
• Please switch the CPU module to RUN after resetting
it. If the same error is displayed again, the camera
recorder module may be defective. Please consult
your local Mitsubishi representative.
• Please restart the network camera.
• Please enable the simple setting mode of the module
extension parameter with the engineering tool, then
execute writing.
• Please switch the CPU module to RUN after resetting
it. If the same error is displayed again, the camera
recorder module may be defective. Please consult
your local Mitsubishi representative.
• Please check the time setting of the CPU module.
• Please restart the network camera.
• Please switch the CPU module to RUN after resetting
it. If the same error is displayed again, the camera
recorder module may be defective. Please consult
your local Mitsubishi representative.
5 TROUBLESHOOTING
5.7 Camera Recorder Module
5
191