Mitsubishi Electric MELSEC iQ-R Series User Manual page 108

Item
Camera Detailed Video
Individua Settings Detail
l Setting
*
Settings
2
PTZ Control Authority
Mode
Camera
Event
Setting
[Communication Test] button
*9
[Camera Access] button
*1 Can be clicked only when selecting "ONVIF supported network camera" for "Camera Type."
*2 Each item is displayed in black when its initial value is changed.
*3 Available when selecting "ONVIF supported network camera" for "Camera Type."
*4 Control characters defined in Unicode cannot be set.
*5 Can be set as additional information for a recording file name.
For the available characters when adding it to a recording file name, refer to the following. (Unavailable characters are replaced with
underscores (_).)
Page 294 ASCII characters that can be used in the format in the saving detail setting
*6 The setting is not required when the simple setting mode is enabled. A value set for a network camera is applied for the operation.
*7 Video quality settings correspond to compression ratios as follows:
High: 20%
Middle: 50%
Low: 80%
*8 Available when all of the following conditions are satisfied:
"ONVIF supported network camera" is selected for "Camera Type."
"Limited" is selected for "Maximum Video Bit Rate."
*9 Can be clicked only when "ONVIF supported network camera" is selected for "Camera Type" and an IP address is already set.
*10 For access, a personal computer and network camera must be connected via Ethernet.
*11 It is not guaranteed that a set IP address is available to access a network camera.
The operation when the network camera cannot be accessed depends on the web browser.
2 PARAMETER SETTING
106
2.3 Module Extended Parameters (Camera Recorder Module)
Description
Video Set the rotation angle of a video captured by a network
Rotation camera.
*6
Angle
Video Set the quality of a video captured by a network camera.
*6*7
Quality Select a video quality according to the compression ratio
of a video.
Maximum Set whether to limit the bit rate of a video delivered from
Video Bit a network camera.
*6
Rate It can be set when the video codec is H.264.
Maximum Set the maximum bit rate of a video captured by a
Video Bit network camera.
Rate Value
*6*8
[kbps]
Set the PTZ control authority mode of a network camera.
Event Set the event notification received from a network
Notification camera.
Set a comment for a camera event.
Event
*5
Comment It can be set when selecting "Motion Detection" for
"Event Notification."
Click this to display the "Communication Test" screen.
Page 108 Communication test screen
Click this to start a web browser (default browser for the
operating system) to access a network camera based on
a set IP address.
The URL of a connection destination is as follows:
• http://(IP address):(TCP port number)/
*10*11
Setting range
ONVIF supported network camera
• 0 degree
• 180 degree
(Default: 0 degree)
• High
• Middle
• Low
(Default: Middle)
• Unlimited
• Limited
(Default: Unlimited)
1 to 50000
(Default: 50000)
• PTZ Enable Mode
• PTZ Preset Mode
• PTZ Disable Mode
(Default: PTZ Enable Mode)
• Motion Detection
• Disable
(Default: Disable)
• Empty (no event comment set)
• Character string up to 32 characters
(Default: Empty)

