8. Move jack (A) to storage position on side of hitch, and
secure with pin (B).
NOTE:
If unit is equipped with a two-point hitch, rotate the
stand to the storage position.
9. Wrap safety chain (A) around hitch and attach to
truck frame. Provide only enough slack in chain to
permit turning.
10. Connect electrical harness (B).
11. Keep
the
slow
reflectors, and lights clean and visible at rear of
mower conditioner.
12. Ensure tires are properly inflated.
13. Do NOT exceed 20 mph (32 km/h).
3.14.4 Transport Lighting
The position of the lighting depends on the transport configuration. If the mower conditioner includes the Road
Friendly Transport system, refer to
conditioner does NOT include the Road Friendly Transport system, refer to
™
Transport
System Option, page
147910
moving
vehicle
(SMV)
Lighting: With Road Friendly Transport
71.
OPERATION
Figure 3.72: Jack in Storage Position
Figure 3.73: Safety Chain and Electrical Harness
sign,
70
™
71. If the mower
Option, page
Lighting: Without Road Friendly
Revision A