Installing Tall Crop Divider - MacDon R113 Operator's Manual

Installing Tall Crop Divider

DANGER
To avoid bodily injury or death from unexpected startup of machine, always stop engine, and remove key
from ignition before leaving operator's seat for any reason.
IMPORTANT:
If mower conditioner will be transported on public roads in the Road Friendly Transport
tall crop dividers. Keep these instructions and install the dividers after the machine is delivered to the customer.
1. Lower the mower conditioner fully.
2. Shut down the tractor and mower conditioner and
remove key.
3. Open cutterbar doors.
Cutterbar Doors, page
4. Remove three bolts (A) and nuts where the divider (B)
will be mounted.
5. Position the divider (B) on mower conditioner, and
reinstall three bolts (A) and nuts. Tighten nuts.
6. Repeat for opposite side.
7. Close cutterbar doors. Refer to
Doors, page 38.
147910
OPERATION
Refer to
3.3.1 Opening
36.
3.3.3 Closing Cutterbar
Figure 3.125: Cutterbar Doors
Figure 3.126: Divider and Hardware
101
™
mode, do not install the
Revision A