Connecting Electrical Wiring Harness - MacDon R113 Operator's Manual

3.7.4 Connecting Electrical Wiring Harness

1. Ensure that Pin #4 (A) in the tractor receptacle is NOT
continuously energized (refer to your tractor operator's
manual). If necessary, remove the appropriate fuse.
IMPORTANT:
Older model tractors may have Pin #4 (A) energized
as an accessory circuit; however, pin position (B)
is used to supply power to the mower conditioner's
brake lights.
2. Connect the mower conditioner wiring harness
connector (C) to the tractor receptacle.
NOTE:
The connector is designed to fit tractors equipped
with a round seven-pin receptacle (SAE J560).
If equipped with the Road Friendly Transport
3. Retrieve Road Friendly Transport
box (A) and place in tractor cab.
through hose support.
4. Locate the connector (C) that branches off the seven
pole trailer plug (A) and attach it to the remote wiring
harness (B).
147910
OPERATION
Figure 3.35: Electrical Wiring Harness
and Receptacle
™
system:
™
system control
Route harness
Figure 3.36: Remote Control
Figure 3.37: Transport Harness
49
Revision A