Attaching With Two-Point Hitch - MacDon R113 Operator's Manual

10. Move jack (A) to storage position on top of hitch, and
secure with pin (B).
11. Proceed to
3.7.3 Connecting Hydraulics, page

3.7.2 Attaching with Two-Point Hitch

Follow these steps to attach Category II, IIIN, and III two-point hitches:
CAUTION
Shut off tractor, engage parking brake, and remove key before working around hitch.
1. Position tractor and align tractor hitch arms (A) with
hitch adapter (B).
2. Shut off tractor and remove key.
3. Remove lynch pins
hitch adapter.
NOTE:
If tractor is equipped with a Category III hitch, use a
bushing (MD #224322) on each hitch pin (D).
4. Secure arms (A) onto adapter pins (D) with lynch
pins (C).
5. Install anti-sway bars (not shown) on tractor hitch to
stabilize lateral movement of hitch arms (A). Refer to
your tractor operator's manual.
147910
OPERATION
47.
(C) and washers from
Figure 3.27: Jack Storage
Figure 3.28: Two-Point Hitch Configuration
45
Revision A