Installing Non-Driven Rotary Deflectors - MacDon R113 Operator's Manual

NOTE:
Arrow indicates forward direction.
2. Place a wooden block between two cutterbar discs to
prevent disc rotation while loosening blade bolts.
3. Remove eight M8 bolts (A) and washers securing the
cover to the non-driven rotary deflector.
4. Remove the four M10 bolts inside the deflector drum
using a 12 in. (305 mm) extension and 16 mm socket.
5. Remove wooden block.
6. Remove rotary deflector.
Installing Non-Driven Rotary Deflectors
DANGER
To avoid bodily injury or death from unexpected start-up or fall of a raised machine, stop engine, remove
key, and engage header lift cylinder lock-out valves before going under machine for any reason.
CAUTION
Exercise caution when working around the blades. Blades are sharp and can cause serious injury. Wear
gloves when handling blades.
147910
MAINTENANCE AND SERVICING
173
Figure 4.119: 16-Foot Mower Conditioner Shown
Figure 4.120: Non-Driven Rotary Deflector
(Top View)
Revision A