Removing Primary Driveline; Installing Primary Driveline - MacDon R113 Operator's Manual

Removing Primary Driveline

DANGER
To avoid bodily injury or death from unexpected startup of machine, always stop engine and remove key
from ignition before leaving operator's seat for any reason.
1. Stop engine, and remove key from ignition.
2. Unhook unit from the tractor. Refer to
Mower Conditioner from Tractor, page
3. Release two lever clamps (A) using a screwdriver or
similar prying tool.
4. Slide driveline shield cone away from gearbox.
5. Loosen nut (A) so that taper pin threads are recessed
inside the nut.
6. Tap nut (A) with a hammer to loosen the taper pin and
release driveline yoke from the shaft.
7. Pull driveline off gearbox.
8. Remove driveline guard if necessary,
Removing Driveline Guard, page

Installing Primary Driveline

DANGER
To avoid bodily injury or death from unexpected startup of machine, always stop engine and remove key
from ignition before leaving operator's seat for any reason.
147910
MAINTENANCE AND SERVICING
3.8 Detaching
51.
refer to
201.
184
Figure 4.147: Driveline Shield Cone and
Lever Clamp
Figure 4.148: Bolt Securing Driveline
to Gearbox
Revision A