Installing Cutterbar Discs - MacDon R113 Operator's Manual

1. Raise mower conditioner fully, shut off engine, and
remove key.
2. Engage lift cylinder lock-out valves. Refer to
Engaging Locks, page
3. Open cutterbar doors.
Cutterbar Doors, page
4. Place a pin (or equivalent) in the front hole of the rock
guard (B) to prevent disc rotation while loosening bolts.
5. Remove four M12 bolts (A) and washers.
6. Remove cutterbar disc cap (A).
7. Remove cutterbar disc (B).

Installing Cutterbar Discs

DANGER
To avoid bodily injury or death from unexpected start-up or fall of a raised machine, stop engine, remove
key, and engage header lift cylinder lock-out valves before going under machine for any reason.
147910
MAINTENANCE AND SERVICING
31.
Refer to
3.3.1 Opening
36.
3.1.1
Figure 4.24: Cutterbar Doors
Figure 4.25: Cutterbar Disc Bolts
Figure 4.26: Cutterbar Disc and Cap
132
Revision A