Installing Cutterbar Spindle Shear Pin - MacDon R113 Operator's Manual

12. Use the safecut spindle-nut wrench and remove nut
(A).
13. Remove the hub (A).
14. Remove shear pins (B). Do NOT damage the pin bore
on the pinion.
NOTE:
Check the nut and hub for damage. Replace if necessary.
15. Refer to
Installing Cutterbar Spindle Shear Pin, page
178.

Installing Cutterbar Spindle Shear Pin

DANGER
To avoid bodily injury or death from unexpected startup of machine, always stop engine and remove key
from ignition before leaving operator's seat for any reason.
1. Fill the space above the bearing with grease.
2. Place the hub (A) on the spindle (C).
3. Install shear pins (B).
147910
MAINTENANCE AND SERVICING
178
Figure 4.132: Cutterbar Spindle
Figure 4.133: Cutterbar Spindle
Figure 4.134: Cutterbar Spindle
Revision A